2000W Class D Amplifier finished board IRAUD2000 IRS2092S

LT-2000

สินค้าใหม่

2000W Class D Amplifier finished board IRAUD2000 IRS2092S.

รายละเอียดเพิ่มเติม

Initial delivery costs estimate :67.00 ฿

จัดส่งภายใน 15-30 วัน

การซื้อสินค้านี้ คุณจะได้รับคะแนนสะสมจำนวน 62 คะแนนสะสม. คะแนนสะสมของคุณจะรวมเป็น 62 คะแนนสะสม ซึ่งสามารถแปลงเป็นบัตรกำนัลจำนวน 310.00 ฿.


6,200.00 ฿

Free Google QRcode module from Mediacom87

Add to wishlist

รายละเอียดเพิ่มเติม

Technical indicators
 
Voltage range : ± 24V-80V, 40V DC voltage note the following , R6 R7 switch 1.5KΩ/3W resistance .
 
Maximum output power: ( ± 80V DC power supply maximum output power, distortion <0.1% )
 
Dual -channel mode : 350W/8Ω X2
                          700W/4Ω X2
                          900W/2Ω X2 ( ± 62V DC power supply , fan-assisted cooling needs )
                          Bridge mode (mono ) 1200W/8Ω
                          2000W/4Ω
 
Voltage Magnification: 33 times ( inverting amplifier )
Input Sensitivity : 1.6V ( RMS )
Input impedance : 6.1KΩ
Frequency response :0-50KHz ± 1dB
Residual noise voltage : 200uV
Dynamic range :> 100dB
Overheat protection value : 75 ° C
Overvoltage protection values : ± 84V
Use
 
First, the power :
1 , power transformers , power transformer windings must first be connected to the board through the rectifier bridge, auxiliary power 5V-12V transformer can be connected directly to the board.
2 , if the switching power supply can be connected directly to the board , you need to have two sets of main and auxiliary power outputs are ± symmetrical power supply voltage Vice ± 7V - ± 16V.
 
Second, the signal line connection:
1, the dual-channel mode: This mode is 2-channel input , 2 -channel output , a board can form a two-channel amplifier .
  At this point, the band switch should be appropriated to the right (ST position ) , left and right channel audio signals directly into two RCA holes output ( power supply terminal side ) OUT1 OUT2 , respectively, then the left and right channel speaker .
2, the bridge mode (mono ) : This mode is the mono input , mono output .
  At this point, the band switch should be to the left (MON position ) , the audio signal directly into a hole above the RCA (IN1), 2 outputs ( supply -side side ) OUT1 OUT2 respectively connected to the positive and negative terminals of two speakers .

Reviews

No customer reviews for the moment.

Write a review

2000W Class D Amplifier finished board IRAUD2000 IRS2092S

2000W Class D Amplifier finished board IRAUD2000 IRS2092S

2000W Class D Amplifier finished board IRAUD2000 IRS2092S.

19 other products in the same category: